maple classic™ 
managed to make one of the keys for the pocket chip so far! quality isn't great but the printer is working https://computerfairi.es/media/RfeBMYs2yuqQ_VsQrpY
trying different settings resulted in a lot of garbage https://computerfairi.es/media/p2-OgFmMIquum1w8hz0
in the end i managed to make only a single space bar.. i'll try again with the hackerspace printers instead some other day
@squirrel these still look half workable if you sand them?
@dnld they're mostly negative space, the plastic did not extrude
@squirrel that sucks. Is there anyway to recycle these things? It's not that much plastic, but still.
@dnld not that i know of
this isn't half the bad print yield whenever i use a 3d printer here
see the biggest problem with this printer is it's not extruding right... it starts great then a few seconds in the extruder starts jamming and i can find 0 reason why