see the biggest problem with this printer is it's not extruding right... it starts great then a few seconds in the extruder starts jamming and i can find 0 reason why

in the end i managed to make only a single space bar.. i'll try again with the hackerspace printers instead some other day

@squirrel these still look half workable if you sand them?

@dnld they're mostly negative space, the plastic did not extrude

@squirrel that sucks. Is there anyway to recycle these things? It's not that much plastic, but still.

@dnld not that i know of

this isn't half the bad print yield whenever i use a 3d printer here