Rivaclaw🏳️‍⚧️ΘΔ @renbymon@computerfairi.es

Decided to part my hair over one side of my head and I think I look kinda cute????

cw: eye contact

Oh just realised I could save time the whole print job if I hollow out the buck and fill it with something like plaster? Would make it heavier but it would save on around 40 hours of the printing and around 1kg of filament!

For a long time I've wanted to do a Tali cosplay but I never thought that I could with my body shape, but I've seen a Tali cosplayer recently who has a similar body shape to me and it opened my eyes that I could do this. I'm really excited to get started on it! ^^

Need to clean/reorganise the workshop (tonight/tomorrow's job) so I can start painting what I'm already working on, and with the workshop reorganised I can set up the 3D printer again and get to printing the Tali helmet while doing other projects!

The Tali helmet is gonna take around 135 hours (not in one sitting) to fully print. I could reduce the printing time by editing the buck for the visor and removing a lot of its internal shape, but that's something to think about later.

Gonna do it. Gonna do a Tali cosplay! 💜

@ZephyrDerg Me too and I really want to cosplay as her! 💜

@philpem Not sure if I can get it in time for that, maybe next year, but I am definitely going to get it! 💜​

@Velux *wiggle!!* 💜💜

@Velux Me too, gosh!! Always wanted to do a Tali cosplay but kept telling myself I could never pull it off but screw that I wanna be Tali! 💜

I just realised that there's nothing stopping me from cosplaying as Tali, from Mass Effect, other than my brain being dumb. X)

@Velux @dragonarchitect Seconded! 💜

@AutumnGoGoGoat@furry.energy I remember not long after I passed my driving test and got a car I'd woken up at 2am and laid in bed for two hours trying to get back to sleep and then just drove to the local maccies (I was wide awake) and just had breakfast like this.